User Manual Part 1

Compliance Statements

Taiwan DGT

August 14, 2007, 2.00 Document Classification: Proprietary Information Page 67

A.4 Taiwan DGT

2.4 GHz Band Products

NCC

「本產品內含射頻模組：XXXyyyLPDzzzz-x

A.3

A.4

Industry Canada Statement

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two

conditions:

1) this device may not cause interference and

2) this device must accept any interference, including interference that may cause undesired operation of the

device

This device has been designed to operate with an antenna having a maximum gain of 1.51dBi.

Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna

impedance is 50 ohms.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the

EIRP is not more than required for successful communication.

IMPORTANT NOTE:

IC Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and

2) The transmitter module may not be co-located with any other transmitter or antenna,

3) For all products market in Canada, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied

firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change.

As long as 3 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still

responsible for testing their end-product for any additional compliance requirements required with this module installed (for

example, digital device emissions, PC peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location

with another transmitter), then the IC authorization is no longer considered valid and the IC ID can not be used on the final

product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the

transmitter) and obtaining a separate IC authorization.

End Product Labeling

This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be

maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains

IC: 2878D-74487504”.

Manual InformationTo the End User

The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module

in the user's manual of the end product which integrates this module.

The end user manual shall include all required regulatory information/warning as show in this manual.

2.42