User Manual Part 1

CB-82/MB-82/EC-82/MC-82
User Guide
Doc. No. MV-S800473-00 Rev. B CONFIDENTIAL Copyright © 2007 Marvell
Page 60 Document Classification: Proprietary Information August 14, 2007, 2.00
3.5.2 Advanced Tab—Miscellaneous
3.6 AutoLink Tab
To enable AutoLink mode, proceed as follows:
1. Toggle the AutoLink button on the Access Point to enable AutoLink mode.
Figure 49: Miscellaneous Section
Table 23: Advanced Tab Miscellaneous Section Description
Field Description
Auto connect if link loss or no
connection (use checked profiles in
<Profile Manager>)
Clear this check box to disable the auto-configuration feature.
Whenever there is a link loss, auto-configuration tries to
establish a connection to the checked profiles in the Profile
Manager window.
Enable WMM Select this check box to enable/disable the Wireless Multimedia
Enhancements (WMM) feature.
BoostMode Select this check box for performance enhancement.
Enable WPS Select this check box to enable Wireless Provisioning Services
(WPS).
Worldwide Regulatory Domain Select this check box to set the regulatory domain
DFS Mode Select this check box to enable Dynamic Frequency Selection
(DFS)
Figure 50: Access Point AutoLink Button