Instructions / Assembly

4.3 OPTIONAL CABINET AND SUPPORT FRAME
Carefully measure and sketch the cut-out area according to the measurements taken from the actual
sink. Cut out the counter-top. Construct a wood support frame (not included) inside the cabinet opening.
Use 2 x 4 lumber and 1/2" plywood. Provide adequate clearance for water supplies between the
support and finished wall. Locate and cut a hole for the drain. Route the water supply lines and drain
Piping(NOT included). Clean the countertop around the cutout.
2x4 Frame
Water Supplies
Countertop
2x4 Frame
Clearance Hole for Sink Drain
1/2" Plywood
Support
4.4 TEMPORARILY INSTALL SINK
Check for alignment and clearance, then trace around the outside edge of the sink as a guide for
installation location and application of sealant. Remove sink.
Assembly Instructions
Fireclay Wall Mount Sink
[e-mail]
361-315-7198
- 6 -