Fireclay Wall Mount Sink Assembly Instructions Farm Style Wall Mount Sink -1- 361-315-7198 Kit.Simon@outlook.
Fireclay Wall Mount Sink Assembly Instructions Inspect the ceramic sink to ensure no damages have occurred while in shipping. Observe all plumbing and building codes in accordance with your state and local requirements. Additional floor and wall preparations may be necessary to avoid damage to the product. Make sure to purchase the correct cabinet for your undermount sink. Installation with laminate countertop not recommended. All dimensions are nominal! Be sure to measure your cabinet to installation.
Fireclay Wall Mount Sink Assembly Instructions 1. INSTALLATION OPTIONS We recommend Undermount kitchen sink installation. Ensure there is adequate room for the faucet and backsplash installations. The cabinet designs illustrated below are intended as suggestions only. Your specific installation requirements may vary from those shown. Before proceeding, determine whether or not the sink will be installed with the front apron exposed. Other basic cabinet design options are shown below for your converience.
Fireclay Wall Mount Sink Assembly Instructions 3. SUGGESTED TOOLS AND MATERIALS Framing Square Safety Glasses Pencil Tape Measure Level Thread Sealant Wood Shims Basin Wernch Drill Hacksaw Sealant - We recommend the use of a stone, marble and granite silicone caulk or a general purpose silicone sealant. Installation tools are not provided, please prepare by yourself. 4. INSTALLATION STEPS 4.1 MEASURE ACTUAL SINK Measure the actual size of the sink below the rim flange.
Fireclay Wall Mount Sink Assembly Instructions 4.2 OPTIONAL HANGER BRACKETS Determine the desired height. Sink should be installed between 31 in. and 34 in. from the top of the sinks lip to the floor. The center of the slots on the steel hangers should be 11.4-in to 11.8-in apart, and should sit on the back of the sinks base. Mark thesemeasurements with a pencil, using a level to draw a plumb line for the screws. Hold thesteel hangers level and mark the locations of the holes on the walls.
Fireclay Wall Mount Sink Assembly Instructions 4.3 OPTIONAL CABINET AND SUPPORT FRAME Carefully measure and sketch the cut-out area according to the measurements taken from the actual sink. Cut out the counter-top. Construct a wood support frame (not included) inside the cabinet opening. Use 2 x 4 lumber and 1/2" plywood. Provide adequate clearance for water supplies between the support and finished wall. Locate and cut a hole for the drain. Route the water supply lines and drain Piping(NOT included).
Fireclay Wall Mount Sink Assembly Instructions Ceramic Sink Trace Line for Silicone Strainer Basket 4.5 INSTALL SINK Apply a generous portion of silicone sealant inside line traced on counter-top. Carefully lower sink into place and press down firmly. Use guidelines for porper positioning. Using water to dampen your finger, remove excess sealant for a smooth even line. Apply additional sealant if necessary to provide a uniform bead from the rim of sink to the masking tape line as shown.
Fireclay Wall Mount Sink Assembly Instructions 4.6 INSTALL DRAIN -8- 361-315-7198 Kit.Simon@outlook.
