Installation Guide
Tools you will need:
Adjustable Wrench
Notes before installation:
1. Please check that all components are present.
2. Before installation ensure that all feed lines are clear of debris and
on/off valve is present.
3. Ensure water pressure is between 20-125 PSI (Includes combination
of hot and cold feed lines).
4. Pictures in the manual are general in content and may not
represent exactly your purchased faucet. If you are having
difculties please contact a professional plumber.
5. lf you will be away from home for an extended period you should
shut off the main water supply.
Daily maintenance
1. Use a soft cloth and vinegar to remove hard-water spots.
2. Check aerator (if present) regularly for calcium build up or when
water stream is not optimum.
3. DO NOT use caustic cleaning products as the use will break down
nish and will void the product warranty.
4. Acceptable cleaners include vinegar or mild non-abrasive liquid
detergents.
5. lf the water pressure appears to be less than optimum remove,
inspect, clean or replace aerator.
Philips Screwdriver
1. Turn off water supply at valves or main.
2. Position faucet on the sink. From
underneath the sink, secure faucet with
mounting nuts. Hand tighten nuts, check
faucet position, then tighten.
3. Apply teon tape or pipe thread
compound to male faucet threads. Attach
water supply lines to faucet and valves.
4. Install pop-up assembly.
5. Make sure all connections are tight, and
turn on water supply.
6. Unscrew and remove aerator. turn water
on and check for leaks. Run hot and cold
water uninterupted forabout 1 minute to
remove any residue from the lines. Replace
the aerator.
A. Thread mounting nut and bottom gasket
onto drain body. Wrap top threaded end
of the drain body with teon tape.
B. Insert drain body up through the drain
opening. Add screw seat onto drain body.
Hold the drain body with pivot rod opening
facing the back of the sink. Hand tighten
the mounting nut. Insert pop-up stopper.
C. Place pivot rod in proper opening. Slide
pivot nut onto drain body. Tighten rmly,
but DO NOT OVER-TIGHTEN.
D. With lift rod in position in the faucet.
Insert lift rod through lift rod strap and
secure with set screw.
E. Guide the pivot rod through any hole
on the lift rod strap and secure it with the
spring clip. Adjust the height of the lift rod
by resetting the set screw
INSTALLATION GUIDE