Instructions / Assembly

Attach Support Leg (F) to Slat (E).

*** Do not tighten screws & bolts until the entire unit is completely assembled.

Attach Slat (E) to Side Rail Left & Right (C), (D) by using Screw (L) and Screw Driver (not included).

Phillips head screwdriver (not included)

is required for assembly.

Use the Phillips head screwdriver to

tighten the screws.

Cleaning & Care

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a

dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check

that all connections are tight.