Instructions / Assembly

Assembly Instructions 3/3
STEP 3
Turn table to its upright position.
Cover umbrella hole with Cover.
Level table by adjusting the adjustable levelers on bottom of legs. (See Figure 4)
Figure 4
Cover
STEP 2
Turn Top (A) upside down on a soft cloth.
Insert Bolts into pre-drilled holes in Top (A), then tighten. (See Figure 3)
Attach unit to Top (A) with Flat Washers, Spring Washers and Nuts,
tightening Nuts only halfway.
Tighten all Nuts used in Steps 1 and 2.
Cover all Nuts with Caps.
A
Cap
Nut
Spring Washer
Flat Washer
Bolt
Figure 3