Instructions / Assembly

Assembly Instructions 2/3
Nut Cap
Nut
Spring Washer
Flat Washer
Bolt
Nut Cap
Wrench
Nut
Spring Washer
Flat Washer
Bolt
STEP 1
Place Top (A) upside down on a soft cloth.
Insert Bolts into pre-drilled holes in Top (A),
then tighten.
(See Figure 1)
Attach Legs (B) to Top (A) with Flat Washers,
Spring Washers and Nuts, tightening nuts only
halfway with Wrench.
(See Figure 2)
B
B
B
B
IMPORTANT
 Use a soft cloth between these parts and the floor.
 Do not use power tools above 8 volts to assemble.
 Do not tighten all the bolts until each part is properly assembled.
 The unit must be level to work properly. Use the included adjustable levelers to level.
 Keep Wrench as the nuts may need to be tightened in the future.
Figure 2
Figure 1
A