20 05506 0501 ben Queen Headboard IMPORTANT Carefully remove all the parts from the carton and place them individually on a soft cloth to prevent scratches or other damage. Carefully and strictly follow these assembly instructions to ensure a completed product as designed. Do not use power tools above 8 volts to assemble. Part List A, Headboard 1pe <7 C. D. Post Post Hardware List Hex mixing (a) Cam Lock Se raw Cam Lock Hed Cap Alt (Lang) Head Cap Boh (short) Spring Washer 4 pos. (+2 ax) & pos.
( Assembly Instructions 2/4 ) IMPORTANT = Use a soft cloth between these parts and the floor. = Da not use power tools above 8 volts to assemble. + Do not tighten up ali the baits until each part is properly assembled. © Keep Hex Wrench as the blats may need to be tightened in the future. STEP 1 Attach Support (E} to Stretcher (8) with Head Cap Bolts (short). ¥ | § Hand Cap Brit (rhos) Tighten Head Cap Bolts (short) with Hex Wrench.
( Assembly Instructions 3/4 ) STEP 3 Cam back Sere —> Insert Cam Lock Screws into per-drilled holes in Headboard (A), then tighten. STEP 4 Attach Headboard (A) to unit with Cam Locks. {See Figure 3} Figure 3 HB.
( Assembly Instructions 4/4 ) STEP 5 Attach unit to Posts (C) and {D) with Dowels, Head Cap Bolts {long}, Spring Washers and Flat Washers. Dowel Fiat Washer Spring Washer Hand Cap Bolt Lang) Tighten Head Cap Bolts (long) with “x Hex Wrench. (See Figure 4} Fist Washer Spring Washer 0. = Cap Bat (long) Hax Wrench ——p Figure 4 STEP 6 Turn unit over to its upright position. HB.
