Getting Started Guide

Page 9
e) Now that you have set up the connection
address, go ahead and enter in your
Username and Password for that server.
There is no need to change the port.
f) You can follow steps c-e for the remaining
3 connections.
g) If you go back to the main settings
screen, there are other options for setting
up HSTouch.
h) Connection Mode allows you to choose a
default connection for each time you start
HSTouch. (HSTouch will no longer prompt
to choose a connection at the beginning.)
i) Dim Systembar allows for the bottom systembar to be dimmed. Font Scaling allows for changing the scaling
factor.
j) Auto Size allows for auto-sizing of the project being used for your device. Client Name will allow you to change
the name of your device’s HSTouch Client. (For use with HSTouch Designer). Zipcode is used for weather.
k) Now that your Client has been set up, go back to the Main Screen and go to the settings menu on the bottom
right. Click Exit. Now go to your app drawer and click HSTouch. This will allow for any changes to take place.
l) You are now ready to control your home via your device!
Setting Up MyHS
The next step involves going into the HSTouch application and entering in your
Account Username and Account Password.
a) Open up the HSTouch application. It will give you the same prompt as
earlier to Log In to MyHS.
b) The email you used to register is your Username and the password you
used will be used as the Password.
c) Click Ok and HSTouch will now connect.
d) HSTouch will now always connect through MyHS when launching. This will
work from any location and any network.