Getting Started Guide

Page 8
g) HSTouch Server is now enabled. You can now go into HSTouch on your device to configure HSTouch.
Setting Up IP Cameras
For setting up an IP Camera within HS3, follow the instructions below. Note that all Foscam IP Netcams will be
automatically detected by HS3 whereas other cameras will not.
a) Now that HStouch is enabled you should be able to go to Plug-ins->HSTouch Server->HSTouch.
b) At the bottom you will see an IP Camera section. All Foscam cameras will automatically show up here. Yoou will
need to enter the username and password for each camera.
c) For other branded cameras click the Green Plus to add a camera.
d) Here you can name the camera, add the snapshot url (this will include the username and password), and then
set up pan/tilt controls.
STEP #9 – HSTouch Client Setup
Here you will configure your settings and connect
to your HomeSeer system to allow for control
from your device. Follow the instructions below to
set up the HSTouch Client. To configure these
settings on iOS, go to the Settings app and scroll
down to HSTouch and proceed with step b.
a) HSTouch will prompt you to select a
server or settings. Click settings. (The first
launch will require an initial setup.) A
menu on the bottom right will pop up.
Click Settings again. (This menu can also
be used to switch between servers, go to
settings, or exit the app.)
b) Within the settings you are given multiple
options. Servers 1-4 allow you to
configure each server for different
locations.
c) Select the server you would like to have
as your Home setup.
d) Configure a Label for that HomeSeer
system. Click Address to enter the IP
Address or Domain of the HomeSeer
System.