Getting Started Guide

Page 6
STEP #6 – Importing, Editing and Controlling Your Z-Wave Devices
Importing devices is only necessary if you are using the Aeon Labs Z-Stick to configure your Z-Wave network, otherwise
that step can be skipped. You’ll need to import that network into your HomeTroller, so that your devices can be
monitored and controlled. Here’s how to do that:
Importing Z-Wave Devices
b) From the web interface, use the pull down menus to navigate to the Z-Wave Controller Management page
(PLUG-INS > Z-Wave > Controller Management).
c) Locate the “Z-Wave Interfaces” area and expand the section of your Z-Wave Controller. Open the “Actions:”
menu and choose “Import Node Info from Controller and Scan Devices”.
d) Click the ‘Start’ button below the Actions menu. Your HomeTroller will now import your device information from
the Z-Stick. When done, you’ll receive an acknowledgement such as “Finished with Z-Wave device
synchronization”. Your Z-Wave devices may now be monitored and controlled from the HomeTroller!
Editing and Controlling Your Z-Wave devices
a) From the web interface, use the pull down menus to navigate to the Device Management Page (VIEW > Device
Management). Click the “Show All” button in the upper right hand area of the page. A list of all your devices will
now be displayed.
b) To edit the name, location and other properties of any device, click the Name.
c) To control the device, use the buttons in the Control column.
d) The Last Change column specifies when the device was last controlled via locally, HS3 (manually or event), or
HSTouch.
e) The Address represents which Z-Wave network the device is added to and then the Node ID is after the hyphen.
Configuring Device Settings
a) From the web interface, go to your Device Management page and click on the device you wish to configure.
b) Click on the Z-Wave tab.
c) Here you can Rescan, Remove, Test, Optimize, and Audit the node. Associations can also be set here.
d) Expanding the Settings section will allow you to change the wake-up interval for battery operated devices. Here
you will also see many settings for different parameters depending on the device.