User Guide

HomeSeer | 10 Commerce Park North, Unit 10 | Bedford, NH 03110 | HomeSeer.com | Doc: HS-MS100-en-v1.0b
ADVANCED CONFIGURATION (accessible via the “Root device” in a HomeSeer System. Before adjusng these sengs, tap the
network buon 4 mes to wake the unit.)
Parameter Sengs
12
Moon Sensor Sensivity
Available: 0-8, 0=moon sensor disabled, 1=low sensivity, 8=high sensivity,
Default: 8 | Size: 1 byte
14
Enable / Disable Basic Set Command
Available: 0=disable, 1=enable
Default: 0 | Size: 1 byte
15
Set Value for Basic Set Command
Available: 0=Sends 255 value when moon sensed, sends 0 value when moons mes out
Available: 1=Sends 0 value when moon sensed, sends 255 value when moons mes out
Default: 0 | Size: 1 byte
17
Enable Shock Sensor
Available: 0=disable, 1=enable
Default: 1 | Size: 1 byte
18
Moon Timeout Interval
Available: 0-65525 (seconds)
Default=600 | Size: 2 bytes
32
Set Value for Low Baery
Available: 0-50 (%)
Default=20 | Size: 1 byte
LIMITED WARRANTY
HomeSeer Technologies, LLC will repair or replace, at its opon, any part of the device, which proves to be defecve in workmanship or
material under normal use, in the USA except in the states of Alaska or Hawaii, for a period of one year from the date the device is pur-
chased. During the warranty period, HomeSeer Technologies, LLC will repair and provide all parts necessary to correct such defects, free of
charge, provided the device has been operated in accordance with the manufacturer's guidelines. The Customer will return the device to
HomeSeer Technologies, LLC for tesng and repair or replacement. Should you need service, during warranty period or beyond, contact
HomeSeer to obtain return authorizaon before shipping your device to HomeSeer Technologies, LLC.
SPECIFICATIONS
Operang Temp Range 0ºC to 40ºC | For Indoor Use Power Requires (1) CR123A Baery
Z-Wave Frequency | Range
Z-Wave Cercaon
908 MHz (US) | Up To 300 Ft line of sight
Z-Wave Plus
Dimensions Sensor with Mount: 2 x 2 x 2 (inches)
Note: baery sensor operaon is disabled on units that are line powered.
Z-Wave Associaon Informaon
HS-MS100+ supports Group 1 associaon. Group 1 reports the sensor’s status and baery if running on baeries.
Notes
Important: Line-powered devices funcon as Z-Wave repeaters. If you’ll be powering HS-MS100+ with baeries, include it into
your network ON BATTERY POWER to prevent it from repeang Z-Wave commands. This funconality would quickly deplete
your Moon Sensor’s baeries.