Instructions / Assembly

Step C: Mark and cut bottom plates to fit.

page 8

Step A: Measure a square pad

at 92”x144” and snap lines as

shown. Make sure layout is pre-

cisely square.

Pad is square when diagonal

measurements are the same.

Step B: Lay out 6’ pressure treated bottom plates as shown.

Step D: It is recommended put

a layer of clear silicone sealer

under bottom plates.

Step E: Make sure bottom plate

layout is square. It is square

when diagonal measurements

are equal.

Step F: Fasten bottom plates to

surface using concrete screws,

tapcons, or fastener equivalent

spaced every 12”.

Bottom Wall Plate Layout

for Units without floor

If you purchased the optional floor, please proceed to page 9.