Instructions / Assembly

Step 3: Lay out floor as shown.

Note: See attached drawing for

appropriate measurements.

Step 8: Fasten plywood sections to floor joists using 2-1/4” galvanized nails spaced 8” apart. Note: It is

important to align plywood flush with floor joist edges.

Tip: It is important that the floor is level before proceeding to next steps.

page 7

Step 4: Attach bandboard to floor joists using two 3” galvanized nails

per joist. Make sure top of joists are flush with top of bandboard.

Step 5: Attach outside band-

board joists together as shown.

Step 6: Make sure floor is square.

Floor is square when diagonal

measurements are equal.

Step 7: Layout plywood floor

pieces as shown.