Instructions / Assembly

Ramp Assembly

page 36

Door Kick Strip Installation

Step 114: Fasten bottom door kick strip beneath door using 2-1/4” galvanized nails as shown.

Step 115: Layout 6’ treated ramp

pieces as shown

Note: If you did not purchase

the optional floor, the ramp is

not included.

Step 116: Find center of (only)

one 2x4 treated ramp piece and

cut in half for ramp bottom brace.

Step 117: Layout ramp pieces

and make sure edges are pre-

cisely straight, using bottom

brace for straight edge as shown.

Step 118: Measure in 12” from

each end as shown.

Step 119: Fasten cut bottom braces (see step 116) to bottom of

ramp using 3” nails as shown.