Instructions / Assembly

Door Trim Installation
page 31
© Suncast Corporation
Step 83: Remove door trim mate-
rials from package.
Door Trim Material List:
2 - 3-1/2”x73-1/2” 5/8 plywood
1 - 3-1/2”x78-3/4” 5/8 plywood
2 - 1”x4”x73-1/2” painted trim
1 - 1”x4”x78-3/4” painted trim
1 - 1”x3”x81” painted trim
Step 84: Make a mark 3/4” above
door header at both ends of door
opening.
Note: If siding pieces above were
installed properly the bottom
edge of the siding should be 3/4”
above door header.
Step 85: Fasten unpainted door
trim strip aligning with edge of
siding or with 3/4” mark.
Step 89: Attach painted 1x4 to
5/8” plywood piece using 2” trim
nails as shown (keep all edges
flush).
Step 90: Attach 1x3x81” flat on
top of 1x4 trim piece as shown.
Step 91: Install top door trim and
properly align as shown.
Step 86: Install opposite unpaint-
ed door trim strip keeping strips
spaced 71-3/4” apart.
Step 87: Install painted trim piece
on top of unpainted strip, keeping
all edges flush as shown. Repeat
on opposite side of door.
Step 88: Fasten unpainted door
trim strip aligning with edge of
siding and with mark.