Instructions / Assembly

Step 11: Remove three 4’x85” sheets of siding and layout on wall as shown.

Step 16: Mark and cut off excess

siding as shown.

Step 15: Install next siding piece as shown, keeping groove reveal

consistent with other openings on sheet. Repeat to end of wall.

Make sure edges are flush.

Siding should run 1-1/2”

down past top of floor.

Step 12: Start siding with overlap

at corner, with 1” overhang at end

of wall.

Step 13: Siding edge should cen-

ter on wall stud as shown.

Step 14: Fasten siding to wall

studs using 2-1/4” galvanized

nails spaced 8” apart.

Step 17: Lift and set wall as

shown.

Step 18: Fasten wall to floor

using 3” nails every 8”.

Step 19: Fasten siding to floor

using 2-1/4” galvanized nails

every 8”.

Page 11

Top of wall with dou-

ble top plate

Bottom of wall

Keep top of siding flush with

top of wall plate