Instructions / Assembly

Bottom Wall Plate Layout

for Units without floor

Step 10: Cut open large package and remove packing materials repeating step 1.

Step 11: Remove top layer of

4’x8’ OSB roof sheeting and

place to the side.

Note: Unpack kit all the way

down to layer 5.

Note: If you purchased the optional floor, please proceed to back wall layout and assembly page.

Step 12: Remove next layer of

kit and set aside.

Step 13: Remove screws from

4’-2”x4” double wall plates and

set aside.

Step 14: Remove all remaining

pieces (excluding pressure treat-

ed 2”x4” bottom wall plates)

Step 15: Measure a square

pad at 13’8”x24’ and snap lines

as shown. Make sure layout is

square, see step 19.

page 8