Instructions / Assembly

Step 2: Layout six 8’ pressure treated 2”x4” floor plates, square joists at one end, and mark off for floor

joists at 12” on center as shown.

Step 3: Layout floor as shown.

Note: See attached drawing

for correct layout.

Step 9: Fasten plywood sections to floor joists using 7d 2-1/4” galvanized nails spaced 8” apart. Note: It

is important to properly align plywood at edges.

Step 4: Attach short floor joists

to long floor joists using using 6d

2” nail and OSB pcs, keeping all

pieces flush at top.

Step 5: Attach floor joists togeth-

er at appropriate measurements

using two 12d 3” nails per joist

Step 6: Attach outside band-

board joists together as shown.

Step 7: Make sure floor is

square. Floor is square when

diagonal measurements are

equal (approximately 27’5/8”).

Step 8: Layout plywood floor

sections as shown.

page 7

Tip: It is

important

to level

floor

before

proceed-

ing to

step.