Instructions / Assembly

Page 22

Step 45: Make a mark at both ends of wall even with bottom of sid-

ing and snap a line. Hammer 4 nails spaced approximately 2’ apart

on line. Do not hammer nails all the way in, keep out - 3/4”.

Step 47: Install 4’x90” sheet of siding by resting it on nails along bot-

tom. Align siding piece at top and edge of front wall stud (not with

edge of siding), left siding splice should fall on the center of wall

stud. Start with 20”x90” on opposite (right) wall.

Sidewall Siding Installation

Step 46: Layout three

4’x90”siding sheets and one

20”x90” sheet as shown.

Step 48: Make sure siding aligns

properly at edge of wall. Nail off

siding every 8” using 7d 2-1/4”

galvanized nails.

Step 49: Each rafter set consists

of two rafters and two gussets,

with the exception of both end

rafters which include only one

gusset.

Rafter Assembly

Incorrect, birds mouth should be

at bottom end of rafter.

If your unit configuration does not include a garage door, repeat previous steps on opposite

gable wall making sure to use correct gable wall configuration. If your unit does include a

garage door, please proceed to page 45 to install gable end wall with garage door opening.

Flush with

front wall

stud