Instructions / Assembly

Step 23: Remove six 4’x90” siding sheets and layout on wall as shown.
Step 24: Start siding with overlap
at corner with 1/2” overhang at
end of wall.
Step 27: Mark and cut off excess
siding as shown.
Step 25: Siding edge should center on wall stud. Fasten siding to
walls using 7d 2-1/4” galvanized nails spaced 8” apart.
Step 26: Install next siding piece as shown, keeping groove reveal
consistent with standard openings on sheet. Repeat to end of wall.
Step 28: Lift and set wall as
shown.
Step 29: Fasten bottom wall
plate to floor using 12d 3” nails
every 8”. Fasten siding into floor
using 7d 2-1/4” galvanized penny
nails every 8”.
Step 30: Use extra wall stud
to brace wall to floor as shown
(make sure wall is plumb before
fastening).
page 12
Siding to
floor
wall plate to
floor