Instructions / Assembly

Bottom Wall Plate Layout

for Units without floor

Step 10: Cut open large package and remove packing materials repeating step 1.

Step 11: Remove top layer of

4’x8’ OSB roof sheeting and

set aside.

Step 13: Remove screws from

4’-2”x4” double wall plates

and set aside.

Note: If you purchased the optional floor, please proceed to back wall layout and assembly page.

Step 12: Remove next layer of

kit and set aside.

Step 14: Remove all remaining

pieces (excluding pressure

treat 2”x4” bottom wall plates)

and.

Step 15: Measure a square

pad at 140”x192” and snap

lines as shown. Make sure

layout is square, see step 19.

Note: The measurement for

a 12’x20’ unit is 140”x240”.

Wall Plate 2”x4”Material List*:

10 - 8’ 6 - 25”

4 - 4’ 6 - 7’

*For a 12’ x 16’ size

page 8