Instructions / Assembly

Tip: It is important to level
floor before proceeding to
next step.
Step 2: Layout four 8’ pressure treated 2”x4” floor plates, mark off for floor joists at 16” on center and
square as shown.
Step 3: Layout floor as shown.
Note: See attached drawing for
measurements.
Step 4: Attach short floor joists to
long floor joists using using 6p 2”
nails and OSB pcs, keeping all
pieces flush at top.
Step 5: Attach floor joists
together at appropriate meas-
urements using 2-16 p. 3” nails
per joist
Step 9: Fasten plywood sections to floor joists using penny 7 p. 2-1/4” galvanized nails spaced
8” apart. Note: It is important to align plywood properly at edges.
Step 6: Attach outside band-
board joists together as shown.
Step 7: Make sure floor is square.
Floor is square when diagonal meas-
urements are equal.
Step 8: Layout plywood floor
sections as shown.
page 7