Instructions / Assembly

Step 26: Install H-clips and insert ripped roofing plywood to com-

plete back roof. Nail plywood into rafters repeating previous steps.

Step 27: Insert the two V-cut

strips of wood on the inside

valley of dormer, keeping

angled end into bottom corner

(cont...)

Step 23: Install dormer plywood sections as shown pushing plywood tight against large plywood sec-

tion.

Note: The plywood should not overhang front of dormer by more than 1/2”.

page 8

Step 24: Repeat on opposite

side of dormer.

No more

than 1/2”

overhang

Step 25: Install plywood roof sheathing on the back side. Start with

full 4x8 piece on the bottom & keep it flush with edges of gable

rafters and edge of wall plate as shown. Nail into rafters every 8”.