Instructions / Assembly

Step 21: Insert dormer siding section as shown, align edges and

fasten to inside of rafter. Nail every 8".

See step 22...

page 7

Step 19: Set dormer section on top of wall and fasten to wall plate,

keeping edges flush. Fasten dormer ridgepole to peak ridgepole

aligning with marks on peak ridgepole.

Step 20: Align back rafter with

dormer ridgepole and cen-

tered at mark on wall top

plate. Toenail rafter to ridge-

pole and back wall.

Step 22: Install front plywood on each side of dormer, fasten only bottom to each rafter. Install H-

clips at top of plywood and insert top plywood strips. After all front plywood sections are in place, nail

front plywood sections to rafters spacing nails 8” apart.

H-clip