Instructions / Assembly

Step 6: Set up back wall (be sure ends are flush with floor) & nail

bottom plate into floor every 12” as shown.

Note: Before nailing make sure bottom wall plate and siding

overhang are tight against the floor.

Step 7: Remove door stabiliz-

er from front wall section.

Step 8: Set front wall repeating

previous steps.

Note: Make sure front door

reveal is consistently

spaced before fastening bot-

tom plate to floor.

page 4

Step 5:Set floor on leveled

site. If needed, level site with

2" of stone or gravel. It is

very important for site to be

level.

Step 4: Assemble floor sections by aligning black marks on floor

and fastening together using pre-drilled screws. Make sure floor

edges are precisely flush.

flush

Step 9: Set gable wall section

repeating previous steps.

Note: Gable sections are

interchangeable, place wall

with large door on desired

gable end.