Operation Manual
31
8 Operation
After teach-in has been performed, simple operator and activation
functions are available via the taught-in control elements, sensors
or the central control unit:
• Each channel can be activated or deactivated in accordance with
the taught-in operator or activation element.
•
If an attempt is made to tamper with the device (tamper contact on the
signalling device, actuator tamper contact, disconnection from power
supply), a tamper signal is sent to the central control unit.
Tamper signals can only be evaluated with a central control unit,
e.g. CCU or alarm central unit.
If alarm scenarios have been congured for these events, they
should be deactivated before commencing service operations
(e.g. battery replacement).
9 Resetting to the
initial state
• Press and hold down the channel button for channel 1 (siren) for at
least 4 seconds. The channel LED starts to ash slowly.
•
To reset the device, press and hold down the teach-in button again
for at least 4 seconds. The LED will now start to ash faster.
• To complete the reset operation, release the channel button; the
LED will go out to conrm that the device has been reset.
Possible error messages:
(This error can only occur if you have a central control unit on which you
have taught-in the device.)
If the LED does not start to ash once the button has been held down for
4 seconds but lights up continuously instead, the device cannot be reset.