Instruction Manual

71
Delete device connections
If the LED of channel 1 starts flashing slowly, the
pump control is activated. If the LED of channel 1
starts flashing quickly, the pump control is deac-
tivated.
• If you do not want to change any parameters, you
can exit the menu by pressing the select button
(B) briefly.
• To switch the parameter from activated to de-
activated or from deactivated to activated, press
and hold down the select button (B) for at least
4 seconds.
9 Delete device connections
To delete the device connections between the floor heat-
ing controller and the wall thermostat, please proceed as
follows:
• Select the channel of the floor heating controller
to which the wall thermostat is connected using
the select button (B)
(see fig. 7) .
• Press the
system button (A) and the select button
(B) of the floor heating simultaneously until the
LED flashes green.
• Restore the factory settings of the wall thermo-
stat (for further information, please refer to the
user manual of the wall thermostat).