Instruction Manual

70
Manual operation
For further information regarding the configura-
tion, please refer to the user manual of the
Homematic IP Wall Thermostat (HmIP-WTH-2).
8 Manual operation
8.1 Switch heating zones on/o
For installation and tests you can manually switch single
heating zones on or o. To switch single heating zones
on or o, please proceed as follows:
• Select the required channel using the select but-
ton (B)
(see fig. 7) .
• Press the select button until the LED (B) flashes
green three times.
The channel will be switched on or o for 15 minutes.
Afterwards, normal operation will be continued for the
heating zone.
8.2 Activating/deactivating the pump control
If you want to use connection terminal (H) for controlling
a heating pump, the heating zone can be switched to
pump control directly via the device. To do this, proceed
as follows:
• Press the select button (B) until the LED of
channel 1 starts flashing green
(see fig. 7) .