Instruction Manual
Table Of Contents
- 1 Hinweise zur Anleitung
- 2 Gefahrenhinweise
- 3 Funktion und Geräteübersicht
- 4 Allgemeine Systeminformationen
- 5 Montage
- 6 Inbetriebnahme
- 6.1 Installationshinweise
- 6.2 Installation
- 6.3 Verhalten nach Einschalten der Netzspannung
- 6.4 Anlernen
- 6.4.1 Anlernen an den Homematic IP Wandthermostaten
- 6.4.2 Anlernen an die Homematic IP Multi IO Box
- 6.4.3 Einen weiteren Fußbodenheizungscontroller hinzufügen
- 6.4.4 Anlernen an den Homematic IP Access Point
- 7 Konfiguration über den Homematic IP Wandthermostaten
- 8 Manuelle Bedienung
- 9 Geräteverknüpfungen löschen
- 10 Fehlerbehebung
- 11 Wiederherstellung der Werkseinstellungen
- 12 Wartung und Reinigung
- 13 Allgemeine Hinweise zum Funkbetrieb
- 14 Technische Daten
- 1 Information about this manual
- 2 Hazard information
- 3 Function and device overview
- 4 General system information
- 5 Mounting
- 6 Start-up
- 7 Configuration via the Homematic IP Wall Thermostat
- 8 Manual operation
- 9 Delete device connections
- 10 Troubleshooting
- 11 Restore factory settings
- 12 Maintenance and cleaning
- 13 General information about radio operation
- 14 Technical specifications
63
Configuration via theHomematic IP Wall Thermostat
• If the wall thermostat is connected to more than
one floor heating controller, please select the re-
quired floor heating controller using the control
wheel.
• Please define if you want to configure the device
parameters (”UnP1/UnP2”) or the channel param-
eters (”ChAn”).
All the settings that are made under “UnP1/UnP2”
will be applied to the entire device. All settings
that are made under “ChAn” will be applied to the
single channels of the device.
• You can individually adjust the line-up time/fol-
low-up time, eco temperatures, intervals etc. ac-
cording to the following table.
Device parameter UnP1:
Parameter Index Value Meaning
Frost pro-
tection
tempera-
ture
P024 3
4
5
...
16
...
19
20
Frost protection activated
2.0 °C
2.5 °C
...
8.0 °C (default)
...
9.5 °C
10.0 °C