Instruction Manual
Table Of Contents
- 1 Hinweise zur Anleitung
- 2 Gefahrenhinweise
- 3 Funktion und Geräteübersicht
- 4 Allgemeine Systeminformationen
- 5 Montage
- 6 Inbetriebnahme
- 6.1 Installationshinweise
- 6.2 Installation
- 6.3 Verhalten nach Einschalten der Netzspannung
- 6.4 Anlernen
- 6.4.1 Anlernen an den Homematic IP Wandthermostaten
- 6.4.2 Anlernen an die Homematic IP Multi IO Box
- 6.4.3 Einen weiteren Fußbodenheizungscontroller hinzufügen
- 6.4.4 Anlernen an den Homematic IP Access Point
- 7 Konfiguration über den Homematic IP Wandthermostaten
- 8 Manuelle Bedienung
- 9 Geräteverknüpfungen löschen
- 10 Fehlerbehebung
- 11 Wiederherstellung der Werkseinstellungen
- 12 Wartung und Reinigung
- 13 Allgemeine Hinweise zum Funkbetrieb
- 14 Technische Daten
- 1 Information about this manual
- 2 Hazard information
- 3 Function and device overview
- 4 General system information
- 5 Mounting
- 6 Start-up
- 7 Configuration via the Homematic IP Wall Thermostat
- 8 Manual operation
- 9 Delete device connections
- 10 Troubleshooting
- 11 Restore factory settings
- 12 Maintenance and cleaning
- 13 General information about radio operation
- 14 Technical specifications
62
Configuration via theHomematic IP Wall Thermostat
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the QR
code. Therefore, please see the sticker supplied or
attached to the device.
• Please wait until pairing is completed.
• If pairing was successful, the LED lights up green.
The device is now ready for use.
• If the LED lights up red, please try again.
• Select the desired solution for your device.
• In the app, give the device a name and allocate it
to a room.
7 Configuration via the
Homematic IP Wall Thermostat
The Homematic IP Floor Heating Controller can
be configured via the Homematic IP Wall Ther-
mostat (HmIP-WTH-2), via the Homematic IP Ac-
cess Point together with the smartphone app or
via the WebUI of the Homematic Central Control
Unit CCU3.
To configure the floor heating controller using the wall
thermostat, please proceed as follows:
• Press and hold down the control wheel of the
wall thermostat to open the configuration menu.
• Select the symbol by turning the control wheel
and confirm by pressing the control wheel briefly.