Instruction Manual

58
Start-up
other HomematicIP devices (e.g. the wall thermostat or
the Multi IO Box) or add it in to the Homematic IP Access
Point. After pairing, the device is configured at the wall
thermostat. After adding to the Access Point, the device is
configured via the Homematic IP app.
6.4.1 Pairing with a Homematic IP Wall Thermostat
Please make sure you maintain a distance of at
least 50cm between the devices.
You can cancel the pairing procedure by briefly
pressing the system button (A) again. This will be
indicated by the device LED (A) lighting red.
If no pairing operations are carried out, pairing
mode is exited automatically after 3 seconds.
If you want to pair the floor heating controller with a
Homematic IP Wall Thermostat, the pairing mode of both
devices has to be activated first. To do this, proceed as
follows:
• Select the channel for pairing a device by pressing
the select button (B) briefly (see fig. 7). Press once
for channel 1, twice for channel 2 etc. The chan
-
nel LED lights permanently for the corresponding
channel.
• Press and hold down the system button (A) for 4
seconds until the LED quickly starts flashing or-