Instruction Manual
Table Of Contents
- 1 Hinweise zur Anleitung
- 2 Gefahrenhinweise
- 3 Funktion und Geräteübersicht
- 4 Allgemeine Systeminformationen
- 5 Montage
- 6 Inbetriebnahme
- 6.1 Installationshinweise
- 6.2 Installation
- 6.3 Verhalten nach Einschalten der Netzspannung
- 6.4 Anlernen
- 6.4.1 Anlernen an den Homematic IP Wandthermostaten
- 6.4.2 Anlernen an die Homematic IP Multi IO Box
- 6.4.3 Einen weiteren Fußbodenheizungscontroller hinzufügen
- 6.4.4 Anlernen an den Homematic IP Access Point
- 7 Konfiguration über den Homematic IP Wandthermostaten
- 8 Manuelle Bedienung
- 9 Geräteverknüpfungen löschen
- 10 Fehlerbehebung
- 11 Wiederherstellung der Werkseinstellungen
- 12 Wartung und Reinigung
- 13 Allgemeine Hinweise zum Funkbetrieb
- 14 Technische Daten
- 1 Information about this manual
- 2 Hazard information
- 3 Function and device overview
- 4 General system information
- 5 Mounting
- 6 Start-up
- 7 Configuration via the Homematic IP Wall Thermostat
- 8 Manual operation
- 9 Delete device connections
- 10 Troubleshooting
- 11 Restore factory settings
- 12 Maintenance and cleaning
- 13 General information about radio operation
- 14 Technical specifications
56
Start-up
6.2 Installation
To install the floor heating controller, please proceed as
follows:
• Open the cover (D). Therefore, release the catch
under the slot for opening (C) by pushing it with
a screwdriver. Remove the cover by pulling it up-
wards (see fig. 5).
• Connect the transformer to the connecting ter-
minals (F) of the floor heating controller.
Press the terminal down using an appropriate
screw driver to open the connecting terminal.
Thread the corresponding cable. Release the ter-
minal to close it and to fix the cable (see fig. 6).
• Plug in the connecting cable of the valve actu-
ators in your heating circuits to the connecting
terminals (G-H). Connect a heating pump using
connecting terminal (G).
• Make sure that all connecting cables are fixed
properly to the cable bushings before closing the
cover.
• Close the cover again. Therefore, push the latch-
es of the cover into the openings provided and
press it down.
• Plug the mains plug of the transformer into a
socket.