Instructions

46 47
8.1.1 Teaching-in without a brightness threshold
• Remove the device from the wall mount (F) and
open the battery compartment (E).
• Press the teach-in button (D) on the HomeMatic
wireless infrared motion detector. The device
LEDashesorange.Theteach-inprocedurecan
now be cancelled by pressing the teach-in button
(D)briey;thiswillcausethedeviceLEDtolight
up red.
• ThedeviceLEDashesgreentoindicatethat
teaching-in has been successful (how long it will
ashfordependsonhowmuchconguration
work has been competed).
• If no teach-in is carried out, teach-in mode will
be exited automatically after 20 seconds. If other
devices are also in teach-in mode, they will be
taught-in.
If the wireless motion detector has already
been taught-in to a central control unit and is
thus blocked for direct teach-in, it can still be
put into teach-in mode as described above.
However, direct teach-in is not possible.
8.1.2 Teaching-in taking a brightness threshold
into account (approx. 10 Lux)
• Remove the device from the wall mount (F) and
open the battery compartment (E).
• Press the teach-in button (D) on the HomeMatic
wireless infrared motion detector for approx. 4
secondsuntilthedeviceLEDstartstoashred.
• Press and release the teach-in button (D) on the
motiondetector.ThedeviceLEDashesorange.
The teach-in procedure can now be cancelled by
pressingtheteach-inbutton(D)briey;thiswill
cause the device LED to light up red.
• ThedeviceLEDashesgreentoindicatethat
teaching-in has been successful (how long it will
ashfordependsonhowmuchconguration
work has been competed).
• Push the cover down onto the battery compart-
ment (E) and turn it clockwise until it locks into
place. Then push the HomeMatic motion detec-
tor back into the wall mount (F) until it locks.
• If no teach-in operations are carried out, teach-
in mode will be exited automatically after 20
seconds. If other devices are also in teach-in
mode, they will be taught-in.