Instructions
62
Configuration menu
Disconnect from mains; Safeguard from switching on again;
Check that system is de-energised; Earth and short circuit;
Cover or cordon o neighbouring live parts;
• Select suitable tool, measuring equipment and, if necessary,
personal safety equipment;
• Evaluation of measuring results;
• Selection of electrical installation material for safeguarding
shut-o conditions;
• IP protection types;
• Installation of electrical installation material;
• Type of supply network (TN system, IT system, TT system) and
the resulting connecting conditions (classical zero balancing,
protective earthing, required additional measures etc.).
6 Configuration menu
When using the wall thermostat without Homematic IP
Access Point, you can select the following modes via the
configuration menu after set-up directly on the device
and adjust the settings to your personal needs. To do this,
proceed as follows:
• By pressing and holding the menu button (E) for
at least 2 s, you will be entering the configuration
menu.
• Select the desired icon via the plus and minus
buttons (D + F) by pressing the menu button
briefly to change the settings of the dierent
menu items.
Press and hold down the menu button (E) to get
back to the previous level.