Instructions

57
Start-up
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, refer to the operating
manual of the Access Point.
After teaching-in the wall thermostat to the
Homematic IP Access Point, the menu of the wall
thermostat will be hidden and settings can be
adjusted only via the Homematic IP app.
To integrate the wall thermostat into your system and
to enable control via the Homematic IP app, you must
teach-in the device to your Homematic IP Access Point
first. To do this, please proceed as follows:
• Open the Homematic IP app on your smartphone.
• Select the menu item “Teach-in device”(see
figure 6).
• Open the battery compartment (G) using a
slotted screwdriver to loosen the wall mounting
plate (see figure 3).
• Remove the insulation strip from the battery
compartment of the wall thermostat.
• Teach-in mode remains activated for 3 minutes.
You can manually start the teach-in mode for
another 3 minutes by pressing the system button
(C) shortly (see figure 6).