Instructions

56
Start-up
(see figure 3).
• Remove the insulation strip from the battery
compartment of the wall thermostat.
• Press and hold down the system button (C) for
at least 4 seconds to activate the teach-in mode.
The device LED (C) starts to flash orange (see
fig. 5). Teach-in mode remains activated for 3
minutes.
• Press and hold down the system button of the
device you want to connect (e.g. the radiator
thermostat – basic) for at least 4 seconds to
activate the pairing mode. The device LED
starts to flash orange. For further information,
please refer to the operating manual of the
corresponding device.
• If teaching-in was successful, the LED lights up
green.
5.1.2 Teaching-in to the Homematic IP Access Point
(alternative)
You can connect the device either to the Home-
matic IP Access Point or the Central Control Unit
C
CU2/CCU3. For detailed information, refer to the
Homematic IP User Guide, available for download
in the download area of www.homematic-ip.com.