Instructions
55
Start-up
5.1.1.1 Pairing with a Homematic IP Floor Heating
Actuator
If you want to pair the wall thermostat with a HomematicIP
Floor Heating Actuator, the pairing mode of both devices
has to be activated first. To do this, proceed as follows:
• Select the required channel of the floor heating
actuator and activate the pairing mode using a
long button press. The device LED starts to flash
orange. For further information, please refer to
the user manual of the floor heating actuator.
• Open the battery compartment (G) using a
slotted screwdriver to loosen the wall mouting
plate (see figure 3).
• Remove the insulation strip from the battery
compartment of the wall thermostat.
• Press and hold down the system button (C) of the
wall thermostat for at least 4 seconds to activate
the pairing mode. The device LED (C) flashes
orange (see figure 4).
• If teaching-in was successful, the LED lights up
green.
5.1.1.2 Pairing with other Homematic IP devices
To connect the wall thermostat with another
HomematicIP device, the pairing mode of both devices
has to be activated. To do this, please proceed as follows:
• Open the battery compartment (G) using a
slotted screwdriver to loosen the wall bracket