operation manual
Table Of Contents
- 1 Information about this manual
- 2 Hazard information
- 3 Function and device overview
- 4 General system information
- 5 Start-up
- 6 Operating modes and configuration
- 7 Operation
- 8 Replacing batteries
- 9 Troubleshooting
- 10 Restore factory settings
- 11 Maintenance and cleaning
- 12 General information about radio operation
- 13 Technical specifications
84
Restore factory settings
1x long red
lighting
Transmission
failed or duty
cycle limit is
reached
Please try again
(see sec. „9.2
Command not
confirmed“ on
page 81 or „9.3
Duty cycle“ on
page 81).
6x long red
flashing
Device
defective
Please see your
app for error
message or
contact your
retailer.
1x orange
and 1 x green
lighting (after
inserting
batteries)
Test display After the test
display
has stopped,
you can continue.
10 Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the wall thermostat,
please proceed as follows:
• To remove the electronic unit (B) from the frame,
take hold of the sides of the electronic unit and
pull it out (see figure 6).
• Remove a battery.