operation manual
Table Of Contents
- 1 Information about this manual
- 2 Hazard information
- 3 Function and device overview
- 4 General system information
- 5 Start-up
- 6 Operating modes and configuration
- 7 Operation
- 8 Replacing batteries
- 9 Troubleshooting
- 10 Restore factory settings
- 11 Maintenance and cleaning
- 12 General information about radio operation
- 13 Technical specifications
77
Operating modes and configuration
device parameters (”UnP1/UnP2”) or the channel
parameters (”ChAn”).
• You can individually adjust the line-up time/
follow-up time, eco temperatures, intervals etc.
For further information regarding the configuration
options, please refer to the user manual of the floor
heating actuator.
6.10 Communication test
You can check the connection between your
Homematic IP Wall Thermostat and the Homematic
IP Floor Heating Actuator. During this test, the wall
thermostat transmits a switching command to the floor
heating actuator. Depending on the current status of the
actuator, the device is switched on or o for confirmation
after receiving the command.
• Press and hold down the control wheel (E) to
open the configuration menu.
• Select the
symbol by turning the control wheel
and confirm by pressing the control wheel briefly.