Instructions
Table Of Contents
- 1 Remarques sur la notice
- 2 Mises en garde
- 3 Fonction et aperçu de l‘appareil
- 4 Informations générales sur le système
- 5 Mise en service
- 6 Remplacement des piles
- 7 Élimination des défauts
- 8 Restauration des réglages d’usine
- 9 Entretien et nettoyage
- 10 Remarques générales sur le fonctionnement radio
- 11 Caractéristiques techniques
- 1 Hinweise zur Anleitung
- 2 Gefahrenhinweise
- 3 Funktion und Geräteübersicht
- 4 Allgemeine Systeminformationen
- 5 Inbetriebnahme
- 6 Batterien wechseln
- 7 Fehlerbehebung
- 8 Wiederherstellung der Werkseinstellungen
- 9 Wartung und Reinigung
- 10 Allgemeine Hinweise zum Funkbetrieb
- 11 Technische Daten
- 1 Information about this manual
- 1 Advertencias sobre estas instrucciones
- 1 Note su queste istruzioni
- 2 Indicazioni di pericolo
- 3 Funzioni e vista d'insieme dell'apparecchio
- 4 Informazioni generali sul sistema
- 5 Messa in funzione
- 6 Sostituzione delle batterie
- 7 Risoluzione dei guasti
- 8 Ripristino delle impostazioni di fabbrica
- 9 Manutenzione e pulizia
- 10 Informazioni generali sul funzionamento via radio
- 11 Dati tecnici
- 1 Instructies bij deze handleiding
- 2 Gevarenaanduidingen
- 3 Werking en overzicht van het apparaat
- 4 Algemene systeeminformatie
- 5 Inbedrijfstelling
- 6 Batterijen vervangen
- 7 Storingen oplossen
- 8 Herstellen van de fabrieksinstellingen
- 9 Onderhoud en reiniging
- 10 Algemene instructies voor het draadloze bedrijf
- 11 Technische gegevens
29
Operation
TIN) in the app or scan the QR code. The device number can be
found on the sticker supplied or attached to the device.
• Please wait until pairing is completed.
• If pairing was successful, the device LED (G) lights up green. The
device is now ready for use (see figure 6).
If the device LED lights up red, please try again.
• In the app, give the device a name and allocate it to a room.
• Set up access using the free Homematic IP app.
• Only insert the Keypad into the wall bracket after installation.
5.2 Installation
The Keypad housing has a drainage hole (K). Open it with a sharp
tool if necessary.
Please read this entire section before starting the installation.
5.3 Installing the wall bracket
When selecting a mounting location and drilling in the vicinity of
switches or socket outlets, check for electrical wires and power
supply cables.
The mounting location should be protected from the weather and
not exposed to direct sunlight or other sources of heat radiation.
To install the wall bracket (A), proceed as follows:
• Choose a suitable site for installation.
• Remove the keypad (B) from the wall bracket (A), by inserting a
thin object into the hole on the bottom of the wall bracket and
releasing the latch (M) (see figure 3).