operation manual

Start-up

holes of the switch actuator on the wall (see ﬁg.

4).

• Use an appropriate drill to make the 5 mm holes

as illustrated.

• Use the screws and plugs supplied to fasten the

switch actuator.

6 Start-up

6.1 Installation instructions

Please read this entire section before starting to

install the device.

If changes or works have to be made on the

house installation (e.g. extension, bypass of

switch- or socket inserts) or the low-voltage dis-

tribution for mounting or installing the device, the

following safety instruction must be considered:

Please note! Only to be installed by persons

with the relevant electro-technical knowledge

and experience!*

Incorrect installation can put

• your own life at risk;

• and the lives of other users of the electrical sys-

tem.