operation manual

32
Start-up
To teach-in the temperature and humiditiy sensor, please
proceed as follows:
• Open the Homematic IP app on your smart-
phone.
• Select the menu item “Teach-in device”.
• Remove the cap (A) if required (see fig. 2) .
• Remove the insulation strip from the battery
compartment (B) of the temperature and humid-
ity sensor to activate the device. Pairing mode
remains activated for 3 minutes.
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button (C)
shortly (see figure 5).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the device LED (C)
lights up green. The device is now ready for use.
If the device LED (C) lights up red, please try
again.