Instructions

Replacing batteries

correct polarity as marked.

• Push the cover down onto the battery

compartment (D) and turn it clockwise until it

locks into place.

Once the battery has been inserted, the

motion detector

will perform a self-test (approx. 2 seconds). Afterwards,

initialisation is carried out. The LED test display will

indicate that initialisation is complete by lighting up

orange and green

(see sec. „9.2 Error codes and ﬂashing

sequences“ on page 43)

Caution! There is a risk of explosion if the battery

is not replaced correctly. Replace only with the

same or equivalent type. Never recharge non-

rechargeable batteries. Do not throw the batter-

ies into a ﬁre. Do not expose batteries to exces-

sive heat. Do not short-circuit batteries. Doing so

will present a risk of explosion.

Used batteries should not be disposed of with

regular domestic waste! Instead, take them to

your local battery disposal point.