Instructions

40
Function test
7 Function test
The function test is only activated if the motion
detector has already been connected.
Up to 10 minutes after connecting the device or estab-
lishing the power supply (if the device has already been
connected), the device LED (E) indicates detected mo-
vements. The LED flashes green with every movement
detected. In this way, the detection range and sensitivity
can be checked directly on the device.
8 Replacing batteries
If the battery symbol is displayed via the app or an empty
battery is indicated on the device (see sec. „9.2 Error
codes and flashing sequences“ on page 43), replace
the used batteries by two new LR6/mignon/AA batteries.
You must observe the correct battery polarity.
• The battery compartment (D) is located on the
base unit. To open it, you must remove the base
unit from the wall mounting bracket (A) (see
figure 5).
• Turn the battery compartment cover (B) of the
motion detector anti-clockwise and lift if o.
• Insert two new 1.5 V LR6/mignon/AA batteries
into the battery compartment (D), observing the