operation manual

Troubleshooting

cover and pushing it upwards until it latches into

place.

Once the batteries have been inserted, the

motion de-

tector

will perform a self-test (approx. 2 seconds). After-

wards, initialisation is carried out. The LED test display

will indicate that initialisation is complete by lighting up

orange and green

(see sec. „9.3 Error codes and ﬂashing

sequences“ on page 40)

Never recharge standard batteries. Do not throw

the batteries into a ﬁre. Do not expose batteries to

excessive heat. Do not short-circuit batteries. Do

ing so will present a risk of explosion.

Used batteries should not be disposed of with

regular domestic waste! Instead, take them to

your local battery disposal point.

9 Troubleshooting

9.1 Weak batteries

Provided that the voltage value permits it, the motion de-

tector will remain ready for operation also if the battery

voltage is low. Depending on the particular load, it may

be possible to send transmissions again repeatedly, once

the batteries have been allowed a brief recovery period.

If the battery voltage is too weak, this will be displayed