operation manual

37
Function test
7 Function test
The function test is only activated if the motion
detector has already been taught-in.
Up to 10 minutes after teaching-in or inserting the batter-
ies the device LED (B) indicates detected movements. If a
movement is detected, the device LED flashes red.
In this way, the detection range and sensitivity can be
checked directly on the device.
8 Replacing batteries
If the battery symbol is displayed via the app or an emp-
ty battery is indicated on the device (see sec. „9.3 Error
codes and flashing sequences“ on page 40), replace
the used batteries by two new LR6/mignon/AA batteries.
You must observe the correct battery polarity.
To replace the batteries of the motion detector, please
proceed as follows:
• Open the battery compartment (C) on the rear
by pushing the battery compartment cover (D)
down or by removing it from the wall mounting
bracket (E) (see fig. 4).
• Insert two new 1.5 V LR6/mignon/AA batteries
into the battery compartment, making sure that
you insert them the right way round (see figure 6).
• Close the battery compartment by replacing the