operation manual

36
Start-up
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button (B)
shortly (see figure 5).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the device LED (B)
lights up green. The device is now ready for use.
If the device LED (B) lights up red, please try
again.
After the teach-in procedure has been finished,
the function test of the motion detector starts
(see „7 Function test“ on page 31).
• Select the desired solution for your device.
• In the app, allocate the device to a room and give
the device a name.