operation manual

Mounting

• Insert the plugs into the bore holes.

• Place the wall mounting bracket and turn the

screws into the plug.

• Only insert the motion detector into the wall

mounting bracket after the device has been put

into operation (see sec. „6 Start-up“ on page

35).

5.1.2 Adhesive strip mounting

For the installation with adhesive strips, please proceed

as follows:

• Choose a site for installation.

• Depending on the installation site - wall or corner

- ﬁx the adhesive stripes to the middle or on the

side of the wall mounting bracket (E).

• Remove the protective ﬁlm and press the wall

mounting bracket (E) to the desired location.

Make sure that the mounting surface is smooth,

solid, non-disturbed, free of dust, grease and sol-

vents to ensure long-time adherence.